Electrical
Add or replace outlet / GFCI: what it costs in Massachusetts
Wide range: this job varies a lot. Itemize your quote for a better answer.
How this range is built
| Part of the job | Low | High |
|---|---|---|
| Parts and materials | $15 | $120 |
| Labor: 1 to 3 hours × $105 to $145 an hour | $105 | $435 |
| Fees: disposal, permits, supplies | $0 | $150 |
| Total, rounded | $120 | $710 |
The hourly rate is the BLS Occupational Employment and Wage Statistics, May 2025 average pay for this trade in Boston, $40.08 an hour, times 2.6 to 3.6 to cover what a contractor bills (overhead, tools, insurance, profit). Materials are a band from basic to high-end. Full method.
Not a repair shop, estimates only. Typical range, estimate. Not a quote. Your home, materials and contractor change the number.
Install a new outlet, or swap in a GFCI outlet in a kitchen, bath, garage or outdoor location.
Got a quote for this job?
Check it with the button above, or share what you were quoted so the range gets better.
Get quotes from local pros
Tell us about the job and your ZIP. Free, takes a minute.
Fair Price is not a contractor or a repair shop. Who sees your request
What is usually included
- Outlet or GFCI device
- Wire connection to existing circuit
- Cover plate
- Test of the circuit
What moves the price
- New circuit vs extending existing wire
- Wall type (plaster, brick, finished basement)
- Distance to panel
- Number of outlets at once
Questions to ask before you say yes
- Is the circuit sized for this use?
- Will you patch the wall?
- Is there a minimum trip fee?
- Are tamper-resistant outlets used?
Can you do it yourself?
Swapping an outlet is a common DIY if you turn off the breaker. New runs through walls are better done by an electrician.
Common questions
Why does my GFCI keep tripping?
Moisture, a worn outlet, or a fault on the circuit can cause it. If it trips again right after a reset, have an electrician check it.
Do I need GFCI outlets?
Code requires them in kitchens, baths, garages, basements and outdoors. Older homes may not have them, and adding them is a safety upgrade.
Can I add an outlet anywhere?
Not always. The wires must come from a nearby circuit with room to spare, and walls or finished ceilings can add labor. An electrician can price the route.
How much does add or replace outlet / gfci cost in Massachusetts?
A typical range is $120 to $710. It is an estimate built from labor wages and material prices, not a quote.
Typical range in 10 metro areas
Only the labor rate changes between cities. Same parts, same hours.
| Area | Typical range, estimate |
|---|---|
| Boston area, Massachusetts | $120 to $710 |
| New York City area | $120 to $740 |
| Los Angeles area, California | $120 to $690 |
| Chicago area, Illinois | $130 to $770 |
| Houston area, Texas | $90 to $590 |
| Dallas-Fort Worth area, Texas | $90 to $590 |
| Phoenix area, Arizona | $95 to $600 |
| Atlanta area, Georgia | $95 to $590 |
| Miami area, Florida | $90 to $590 |
| Seattle area, Washington | $140 to $800 |